| RODE NTV Repair [message #340080] |
Fri, 09 May 2008 13:41  |
joebarefoot1 Messages: 1 Registered: May 2008 |
Welcome |
|
|
I have a RODE NTV and its 12 pin connector at the bottom of the mic is starting to wiggle loose. I have found no obvious way to tighten this from the outside so I unscrewed the cap on the bottom of the mic. This revealed two small screws which I removed. Still the mic does not want to open with a reasonable amount of pressure applied. I am uninterested in forcing the issue in fear of causing further damage. Any one have any experience with this.
Thanks-Joe Doyle
BareFoot Studio
Silver City, NM
|
|
|